CCIE请进,Cisco路由器 设置 traffic shaping.

fargo

<br>
GTS 在关闭 dCEF 能生效.<br>
Class Based Traffic shaping 必须要求打开dCEF,但配置后不能生效.<br>
<br>
Router#sh ver<br>
<br>
Cisco Internetwork Operating System Software <br>
<br>
IOS (tm) RSP Software (RSP-IK9SV-M), Version 12.2(10a), RELEASE SOFTWARE (fc1)<br>
<br>
..<br>
cisco RSP4 (R5000) processor with 262144K/2072K bytes of memory.<br>
<br>
R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache<br>
<br>
Last reset from power-on<br>
<br>
G.703/E1 software, Version 1.0.<br>
<br>
G.703/JT2 software, Version 1.0.<br>
<br>
X.25 software, Version 3.0.0.<br>
<br>
Bridging software.<br>
<br>
Chassis Interface.<br>
<br>
2 VIP2 R5K controllers (2 FastEthernet)(1 ATM).<br>
<br>
2 FastEthernet/IEEE 802.3 interface(s)<br>
<br>
1 ATM network interface(s)<br>
<br>
#----------------------config----------<br>
<br>
<br>
class-map match-any allips<br>
<br>match any <br>
<br>
!<br>
<br>
!<br>
<br>
policy-map test<br>
<br>class allips<br>
<br>bandwidth 15440<br>
<br>shape average 15440000 61760 61760<br>
<br>
interface FastEthernet1/0/0<br>
<br>
no ip proxy-arp<br>
<br>no ip mroute-cache<br>
<br>full-duplex<br>
<br>service-policy output test<br>
<br>no cdp enable<br>
<br>
<br>
---------------Output<br>
Router#sh int shape<br>
<br>FastEthernet1/0/0 nobuffer drop 0<br>
<br>FastEthernet1/0/0(class 2):<br>
<br>cir 15440000, Bc 61760, Be 61760<br>
<br><b>packets output 0, bytes output 0</b><br>queue limit 3860, queue size 0, drops 0<br>
<br>last clear = 00:52:04 ago, shape rate = 0 bps<br>
<br>
我是想在ATM接口实现Traffic shaping但ATM接口下不支持GTS,没有traffic-shape命令<br>
所以想设置class based shaping.我这是先在Fe接口先做试验,但不能生效,why??<br>
<br>
请坛子里的几位高手帮忙.<br>
<br>
<br>
<br>
<br>