能不能上个图？ 我也发现，不同的水龙头，拆卸方法也不同。 把图放上来，大家一起想办法，应该不难。主要是没工具，不知道如何拆。作者: 5years 时间: 26-3-2013 09:42
确认一下。厕所sink是指，厕所的洗手池吧。不是淋浴的，也不是浴缸的。有个图好讨论，LZ或者上网下个图也行。作者: 5years 时间: 26-3-2013 09:53
How to Fix a Leaky Faucet with a Single Handle Design
Let Lowe's guide you through steps for repairing a ball, cartridge or ceramic disk faucet. To repair a faucet, you will first need parts. You can either disassemble the faucet and take the parts to your local Lowe's, or you can by a faucet repair kit. You can also check the manufacturer's directions or the manufacturer's website for the exact parts for your faucet.
First, turn off your water supply. Then turn on of the faucet to relieve any residual pressure. Close or cover the drain. Place a towel in the drain to keep the parts in order and protect the sink.
Pry off any cover that may be over the set screw. Remove the screw and take off the handle. For vinyl handles, pry off the cap and remove the screw. If your model has one, remove the escutcheon. On some models you may have to remove the spout.
Rotating Ball Valve
To disassemble a faucet with a rotating ball valve, remove the cam, the washer and the ball. Carefully remove the seats and springs. If you took off the spout, replace the o-rings and add a little plumbers grease. Then replace the spout. Place the new seats on new springs and set them back in place. Replace the ball, washer and cam; reassemble the handle.
Cartridge
For a cartridge style faucet, first remove the handle. Remove the escutcheon too. Remove the retainer clip or nut. Pull out the cartridge body. If the cartridge is worn or damaged, just replace it. On some cartridges you can just replace the o-rings and add some plumbers grease. Reassemble the faucet.
Ceramic Disc
For a ceramic disc style faucet, start by unscrewing the retainer nut and puling it out. Use a screwdriver to lift out the seals. Before replacing the seals, clean any buildup on the cylinder near the openings. Put the new seals in place. Then reassemble the faucet. When you turn on the water supply, make sure the faucet is in the on position and turn on the water slowly. Too much initial pressure can damage the ceramic discs in the cylinder.
