Certificate IV in Residential Drafting 和机床操作课程（也发珀斯）
再发帖问下前辈们看法（两个课程从是否容易就业以及预期薪水的角度机床肯定难找工作？），上面两个课程我查了下下个学期TAFE可以去读。之前哥们建议过fitter, boilermaker,是不是这两种都是apprenticeship才能读的。polytechnic tafe 只是apprenticeship才可以学welding的。
Residential Drafting 和机床操作课程没要求一定是 Apprenticeship.谢！ I am not sure. I am studying in NSW tafe, whic is not necessary to enroll as apprenticeship. You might check other Tafe. You could choose Statement of Attainment- Welding, which will take one year part time study. I have spent 3 and half years to finish Certificate 3-Engineering Fabrication.Residential Drafting is also good course. You could learn both. If you can use Revit, there are a lot of job too. denghy99 发表于 2-9-2014 09:23
I am not sure. I am studying in NSW tafe, whic is not necessary to enroll as apprenticeship. You mig ...
Thanks, Guy
So, you are studying part time on this CERT III welding course? 3.5 years is not a short time?
Regard to the REVIT. If I only learn it by myself, it's also very difficult for me to get a job?
I have to finish the Cert IV residential drafting course to get a job?
I have finished Certificate IV-Engineering already. I am studying Diploma of Engineering-advance trade.
It is not just to learn Revit software only. You shall have enough knowledge about building and building drawing.
Cert IV residential draftingwill provide both to you.For job, if you are luck, you might get one before you finish Cert IV(in my wife class, about 3 classmates(totally 10) got job before finishing Cert IV engineering drafting ).Otherwise , you still need to strike for job.
页:
[1]